Basler Electric DGC-2020 - Manual (Page 295)

Figure 7-8. Settings Explorer, System Parameters, Sensing Transformers Screen
Relay Control
Front Panel Navigation Path: SETTINGS > SYSTEM PARAMS > RELAY CONTROL
These drop-down menus select the operating mode for the PRE, START, and RUN relays on the back of
the DGC-2020. In general, most machines will use preconfigured functionality; more advanced users may
select programmable. Refer to the appropriate paragraphs in Section 4, BESTCOMSPlus
® Software, for
additional information. See Figure 7-9.
Figure 7-9. Settings Explorer, System Parameters, Relay Control Screen
Auto Config Detection
Front Panel Navigation Path: SETTINGS > SYSTEM PARAMS > AUTO CONFIG DETECT
If the machine connection type is not reconfigurable, disregard this setting. However, if a machine is
reconfigurable, these parameters define how automatic detection of the generator connection type for
some machines is accomplished. Refer to the appropriate paragraphs in Section 4, BESTCOMSPlus
®
Software, for additional information. See Figure 7-10.
9400200990 Rev X DGC-2020 Setup 7-7