Basler Electric DGC-2020 - Manual (Page 13)

Firmware Package
Version and Date
Change
1.13.04, 07/11 •
Enhanced configurable protection.
•
Enhanced synchronizer.
•
Enhanced J1939.
•
Added Q parameter to 51 programmable curve equation.
•
Added Sequenced System Startup logic element.
•
Added Low Fuel logic element.
•
Added Last Unit Shutdown enable/disable setting for generator
sequencing.
•
Added the ability to set IP Address of LSM-2020 through the front
panel.
•
Added governor load sharing over J1939.
•
Improved detection of Intergenset Communications failures.
1.11.02, 11/10
•
Improved time dials for fixed time curves of the 51 function.
1.11.00, 08/10 •
Changed synchronizer slip frequency to have minimum slip rate of
0.01 in increments of 0.01.
•
Added pre-alarms logic for Mains Fail Transfer Fail, Gen Breaker Sync
Fail, Gen Breaker Fail to Close, Gen Breaker Fail to Open, Mains
Breaker Sync Fail, Mains Breaker Fail to Close, and Mains Breaker
Fail to Open.
•
Added status logic for Mains Fail Transfer Complete and Unloading
State.
1.10.00, 03/10
•
Added Loss of Mains Protection (78 Vector Shift and 81 ROCOF).
•
Added Dead Bus Breaker Close Arbitration.
•
Added GM and Cummins as settings for ECU type.
•
Added CAN settings for MTU 50/60 Hz Switch, NMT Alive Transmit
Rate, Generator Parameter Transmit, and Diesel Particulate Filter.
•
Added Modem Setup through the Front Panel HMI.
•
Added settings for Clock Not Set Warning, Gen CT Low Line Scale
Factor, Horn Enable, Not in Auto Horn Enable, Low Line Scale Factor
for 47 function, Alternate Frequency Scale Factors, Alternate
Frequency, Metric Pressure Units, and Dead Gen Close Enable.
•
Added logic for Idle Request, Alternate Frequency Override, Mains Fail
Test, Load Take Over, Alarm Silence, Lamp Test, Generator
Protection, DPF Regeneration Disabled, DPF Regeneration Required,
and High Exhaust Temperature.
•
Added ranges for hours and minutes of Logic Timers.
•
Moved Engine Cooldown, Horn, Single-Phase Override, Auto Config
Detection, and Relay Control for organizational purposes.
9400200990 Rev X DGC-2020 Introduction xi