Basler Electric DGC-2020 - Manual (Page 201)

Figure 4-75. Coolant Temperature
A Sender Points: Accepts up to 11 user-defined sender resistance points.
B Sender Slope: Positive or Negative causes sender points to be sorted and displayed accordingly.
C Sender Point Curve: Automatic plot of sender points data.
D Print This Graph: Click to print sender point curve.
E Save Cool. Data: Click to save file containing sender point data.
F Load Cool. Settings File: Click to clear all user-defined sender data and revert to the factory-default
values.
G Create Cool. Settings File: Click to create a new settings file by entering sender point data.
BESTlogic ™ Plus Programmable Logic
BESTlogicPlus Programmable Logic is used to set all logic functions in the DGC-2020. For detailed
information on using BESTlogicPlus, refer to Section 5, BESTlogicPlus Programmable Logic.
Logic Timers
Refer to Section 5, BESTlogicPlus Programmable Logic, for information on using logic timers.
Settings File Management
A settings file contains all DGC-2020 settings including logic. A settings file assumes a file extension of
“
∗.bst” or “∗.bstx”. It is possible to save the logic only as a separate logic library file on the BESTlogicPlus
Programmable Logic screen. This is helpful when similar logic is required for several devices. A logic
library file assumes a file extension of “
∗.bsl” or “∗.bslx”. It is important to note that settings and logic can
be uploaded to the device separately or together, but are always downloaded together. For more
information on settings file management, refer to Section 3, BESTCOMSPlus. For more information on
logic files, refer to Section 5, BESTlogicPlus Programmable Logic.
9400200990 Rev X DGC-2020 BESTCOMSPlus
® Software
4-91