Sleep mode, Changing a setting, Front panel display structure – Basler Electric DGC-2020 User Manual
Page 44: Sleep mode -4, Changing a setting -4, Front panel display structure -4, Figure 2-2. metering screen branches -4, Metering

•
GEN IC
•
kW A
•
kW B
•
kW C
•
kW TOT
•
kVA A
•
kVA B
•
kVA C
•
kVA TOT
•
ALG IN X (X = 1 to 8) (with AEM-2020)
•
DEF 2 %
•
KW LD%
•
ON LINE
•
# UNITS
•
SYS CAP
•
SYS KW
•
SY KVAR
•
SYS TOTAL KW
•
SYS GEN KW %
Sleep Mode
Sleep mode serves as a power saving feature. If the DGC-2020 is in Off mode or Auto mode not running
and a key is not pressed for more than 15 minutes, the front panel LCD backlight and LCD heater are
turned off. The DGC-2020 resumes normal display operation when any front panel button is pressed or
the genset is started remotely via the ATS input. The DGC-2020 will not go to sleep while in an Alarm
state. If needed, Sleep mode can be permanently disabled via BESTCOMSPlus
® or the front panel.
Changing a Setting
To change a setting, navigate to the setting you want to change and press the Edit key. If you are not
already logged in, you will be asked to enter your password at this time. Use the Up/Down arrows to raise
or lower the value. Press the Edit key again when finished.
Front Panel Display Structure
The front panel display begins with the SUMMARY SCREEN. Pressing the Right arrow key will open the
MAIN MENU screen. The MAIN MENU screen consists of METERING, SETTINGS, and, when enabled,
the ONE-LINE DIAGRAM, indicated by this symbol:
The METERING screen branches are
shown in Figure 2-2. Details of the METERING screen branches follow Figure 2-2. The SETTINGS
screen branches are shown in Figure 2-3. Details of the SETTINGS screen branches follow Figure 2-3.
The ONE-LINE DIAGRAM screen options are shown in Figure 2-4.
Figure 2-2. Metering Screen Branches
ENGINE
●
OIL PRESSURE
●
COOLANT TMP
●
BATTERY VOLT
●
RPM
●
SPEED SRC
●
FUEL LEVEL
●
ENGINE LOAD
●
COOLANT LEVL (Visible when CAN BUS is enabled.)
●
TOTAL RUN TM
●
HRS TO MAINT
●
DEF TANK 1 LVL %
●
DEF TANK 2 LVL %
G
L
P0059-83
ENGINE
GENERATOR
POWER
BIAS CONTROL (Available when LSM-2020 is enabled.)
RUN STATISTICS
ALARMS-STATUS
DIAGNOSTICS
METERING
2-4
DGC-2020 Human-Machine Interface
9400200990 Rev X