Basler Electric DGC-2020 - Manual (Page 43)

appears in the list of SETTINGS. To logout, navigate to SETTINGS > LOGOUT and press the Edit key.
The LOGOUT selection is removed from the SETTINGS list.
If a front-panel key is not pressed for more than 15 minutes, the user is automatically logged out.
Permissions
If communications access is active through the modem or USB, the front panel will display REMOTE
COMMS, FRONT PANEL IS READ ONLY and the summary screen. This informs the user that the front
panel can only be used for viewing metering data and settings information. Remote access must be
ended before modifying settings through the front panel.
Summary Screen and Configurable Metering
The summary screen can be set to standard or scrolling. When set to standard, only the following are
displayed:
•
VOLT
∗
•
AMP
∗
•
PH
∗
•
Hz
•
OIL
•
FUEL/DEF†
•
TEMP
•
BATT
∗ When set to standard, individual phase information can be automatically toggled at a rate set by the
Phase Toggle Delay setting. Navigate to the SETTINGS > GENERAL SETTINGS > FRONT PANEL HMI
screen and edit PH TOG DELAY. When the Phase Toggle Delay is set to zero, information for each
phase is obtained by pressing the Up or Down arrow keys on the front panel HMI. When it is set to a
number other than zero, the display will toggle through the phases automatically at the rate specified by
the Phase Toggle Delay Setting.
† When a Selective Catalytic Reduction (SCR) with Diesel Exhaust Fluid (DEF) exhaust after-treatment
system is implemented, the Summary screen automatically alternates the display of FUEL level and DEF
level.
When the summary screen is set to scrolling, you can select/configure the metering values that are
displayed. Up to 20 values can be displayed and these values will scroll at a delay time specified by the
user. To select a standard or scrolling summary, navigate to the SETTINGS > GENERAL SETTINGS >
FRONT PANEL HMI screen and edit the SUMMARY VIEW. The SCROLL DELAY setting is also found on
this screen.
To select the scrolling values, navigate to the SETTINGS > GENERAL SETTINGS > FRONT PANEL HMI
screen and edit the CONFIGURABLE METERING. The following items may be selected by the user to be
placed in the scrolling summary:
•
NONE (Removes a line from the scrolling list)
•
BLANK (Shows nothing on this line)
•
OIL P
•
TEMP
•
BATT V
•
RPM
•
RPM SRC
•
FUEL
•
RUN HRS
•
GEN VAB
•
GEN VBC
•
GEN VCA
•
GEN VAN
•
GEN VBN
•
GEN VCN
•
BUS Hz
•
BUS V
•
GEN Hz
•
GEN PF
•
kWH
•
GEN IA
•
GEN IB
•
RTD IN X (X = 1 to 8) (with AEM-2020)
•
THRM CPL X (X = 1 to 2) (with AEM-2020)
•
FUEL DELV P
•
kvar A
•
kvar B
•
kvar C
•
kvar TOTAL
•
INJ RAIL PRS
•
TOTAL FUEL USED
•
FUEL TEMP
•
ENG OIL TEMP
•
ENG INTCLR TEMP
•
COOLANT PRESS
•
FUEL RATE
•
BOOST PRESS
•
INTAK MNFLD TMP
•
CHRG AIR TMP
•
ENGINE % LOAD
•
BUS VAB
•
BUS VBC
•
BUS VCA
•
DEF 1 %
9400200990 Rev X DGC-2020 Human-Machine Interface 2-3