Basler Electric DGC-2020 - Manual (Page 302)

5. Phase Toggle Delay - Set the phase toggle delay to a nonzero value if automatic scrolling through the
phase information in the standard overview screen on the front panel is desired. If it is left at zero,
scrolling through phase information is accomplished using the up and down arrow buttons.
6. Initializing Message 1 - This parameter defines the first line of text that appears on the front panel of
the DGC-2020 as it is going through its power up and initializing sequence.
7. Initializing Message 2 - This parameter defines the second line of text that appears on the front panel
of the DGC-2020 as it is going through its power up and initializing sequence.
Figure 7-18. Settings Explorer, General Settings, Front Panel HMI Screen
Device Security Setup
If passwords other than default are desired, use BESTCOMSPlus
® to connect to the DGC-2020 and
change the passwords. Click on Upload Security from the Communications pull-down menu to load the
new passwords. See Figure 7-19.
Figure 7-19. Settings Explorer, General Settings, Device Security Setup Screen
7-14 DGC-2020 Setup 9400200990 Rev X