Basler Electric DGC-2020 - Manual (Page 51)

○ SEQUENCE ID (Displays “0” when LSM-2020 is not connected.)
○ SYSTEM MANAGER (Displays “0” when LSM-2020 is not connected.)
○ START LVL 1
○ START LVL 2
○ STOP LVL
○ START TD 1
○ START TD 2
○ STOP TD
● MAINS FAIL TRANSFER (Visible when Mains Fail Transfer is enabled.)
○ MAINSFAIL XFER STATE
■ DISABLED ( The possible mains fail transfer states are as follows: Power From Mains,
Transfer Timer Active, Transferring to Gens, Power From Gens, Return Timer Active,
Transferring to Mains, Disabled (when DGC is in OFF or RUN modes, or in the alarm state))
○ TRANSFER DELAY (Visible when actively counting and relevant to mains fail transfer.)
○ RETURN DELAY (Visible when actively counting and relevant to mains fail transfer.)
○ MAX TRANSFER TIME (Visible when actively counting and relevant to mains fail transfer.)
○ MAX PARALLEL TIME (Visible when actively counting and relevant to mains fail transfer.)
○ OPEN TRANS DELAY (Visible when actively counting and relevant to mains fail transfer.)
DIAGNOSTICS
● MODBUS RD
● MODBUS WR
● FLASH WR
Figure 2-3. Settings Screen Branches
GENERAL SETTINGS
● FRONT PANEL HMI
○ SUMMARY VIEW
○ SCROLL DELAY
○ PH TOG DELAY
○ LCD CONTRAST
○ SLEEP MODE
○ LANGUAGE
○ CONFIGURABLE METERING
■ ITEM X (X = 1 to 20)
○ ONE-LINE DIAGRAM
● CONFIGURE DATE/TIME
○ YEAR
○ MONTH
○ DAY
○ HOURS
P0059-82
GENERAL SETTINGS
COMMUNICATIONS
SYSTEM PARAMS
PROGRAMMABLE INPUTS
PROGRAMMABLE OUTPUTS
CONFIG PROTECTION
ALARM CONFIGURATION
GENERATOR PROTECTION
BREAKER MANAGEMENT
BIAS CONTROL
MULTIGEN MANAGEMENT (Available when LSM-2020 is enabled.)
LOGIC TIMERS
ENTER PASSWORD
SETTINGS
9400200990 Rev X DGC-2020 Human-Machine Interface 2-11