Basler Electric DGC-2020 - Manual (Page 318)

Figure 7-34. Settings Explorer, Programmable Outputs, Remote Contact Outputs Screen
Configuring Remote Analog Outputs on the AEM-2020
Front Panel Navigation Path: SETTINGS > PROGRAMMABLE OUTPUTS > ANALOG OUTPUTS
There are four remote analog outputs, each configured on its own screen in BESTCOMSPlus
®.
Parameters metered by the DGC-2020 are mapped to these outputs, enabling them to be used as meter
drivers or they can drive analog inputs of external equipment. Ranges for the metered parameter and the
analog output are set up so that when the metered parameter is at the minimum of the parameter range,
the analog output is at the minimum of its output range. Similarly, when the metered parameter is at the
maximum of the parameter range, the analog output is at the maximum of its output range. The
parameters for Remote Analog Output 1 are shown in Figure 7-35.
Figure 7-35. Settings Explorer, Programmable Outputs, Remote Analog Outputs Screen
7-30 DGC-2020 Setup 9400200990 Rev X