Basler Electric DGC-2020 - Manual (Page 212)

Remote Contact Inputs
When an optional CEM-2020 (Contact Expansion Module) is connected, the status of the remote contact
inputs, configurable remote contact input alarms, and remote contact input pre-alarms are shown on this
screen. The status is TRUE when the corresponding LED is red. Refer to Figure 4-90.
Figure 4-90. Metering, Inputs, Remote Contact Inputs
Remote Analog Inputs
When an optional AEM-2020 (Analog Expansion Module) is connected, the status of the remote analog
inputs, remote analog input alarms, and remote analog input pre-alarms are shown on this screen. The
status is TRUE when the corresponding LED is red. Refer to Figure 4-91. Remote Analog Input #1 is
shown.
Figure 4-91. Metering, Inputs, Remote Analog Inputs
Remote RTD Inputs
When an optional AEM-2020 (Analog Expansion Module) is connected, the status of the remote RTD
inputs, remote RTD input alarms, and remote RTD input pre-alarms are shown on this screen. The status
is TRUE when the corresponding LED is red. Refer to Figure 4-92. Remote RTD Input #1 is shown.
Figure 4-92. Metering, Inputs, Remote RTD Inputs
Remote Thermocouple Inputs
When an optional AEM-2020 (Analog Expansion Module) is connected, the status of the remote
thermocouple inputs, remote thermocouple input alarms, and remote thermocouple input pre-alarms are
shown on this screen. The status is TRUE when the corresponding LED is red. Refer to Figure 4-93.
Remote Thermocouple Input #1 is shown.
4-102 DGC-2020 BESTCOMSPlus
® Software
9400200990 Rev X