Apple Final Cut Express 4 - Manual (Page 365)

Chapter 26 Three-Point Editing 365
VI
Performing the Different Types of Edits
The following section tells you how to perform the most common types of edits for
adding content to a sequence. These procedures assume that you’ve already set In
and Out points and destination tracks in the Timeline. For more information, see
Chapter 23, “
Setting Edit Points for Clips and Sequences ,” on page 313 and “ Specifying
Destination Tracks in the Timeline ” on page 339.
Performing an Insert Edit
An insert edit places the source clip into your sequence so that all items after the
insertion point in your sequence are moved forward (or rippled) in the Timeline, to
make room for the clip being added. No clips are removed from your sequence.
You can perform an insert edit with one or more clips. If you perform an insert edit in
the middle of an existing sequence clip, that clip is cut at the insertion point and the
second half is pushed, along with the rest of the footage to the right of the insertion
point, to the end of the newly inserted clip. Even if your destination track is empty, clips
on all other unlocked tracks are moved forward in time, from the insertion point to the
right. Insert edits cause clips in your sequence to be rippled forward.
By definition, an insert edit makes your sequence longer because the duration of the
inserted clip is added to the sequence. Typically, you use insert edits when you want to
add a new shot in the beginning or the middle of your sequence. You can also use an
insert edit to interrupt the action in an existing clip with the action in the newly
inserted clip. The action in the original clip then resumes after the inserted clip.
A B C D
A B C D
Before edit
After edit