Festo Кабели и принадлежности - Manual (Page 91)

3. Installation
3−13
Festo P.BE−SPC200−EN en 0901d
There is a maximum and a minimum permissible mass load.
The mass load depends on:
ć the type of drive used
ć the diameter of the drive used
ć the selected mounting position
ć the operating pressure.
Make sure that in all load situations the effective mass load:
ć is at least equal to the minimum permissible mass load.
This applies in particular when there is no workpiece. If
necessary, fasten an additional mass / mass load to the
slide.
ć the maximum permissible mass load must not be
exceeded, see Tab. 3/1 and Tab. 3/2.
Please note
Minimum mass load.
A pneumatic positioning axis always requires a minimum
mass load. You can find these values in Tab. 3/1 and
Tab. 3/2.
If necessary, this minimum mass load must be ensured
through the use of an additional weight.