Festo Кабели и принадлежности - Manual (Page 163)

4. Commissioning
4−19
Festo P.BE−SPC200−EN en 0901d
4.3.2 Application data for pneumatic axes
The application data describe the general conditions under
which the positioning axis is operated:
Application data Unit Default values Example
Moveable mass without workpiece Kg 7.0 25
Max. mass of the workpiece Kg 1.0 10
Workpiece mass in initial state 1) (Kg, %) 100 % 2) 0 kg 2)
Supply pressure bar 6 6
Mounting position ° 0 −90
Mounting offset mm 0.00 0.00
Project zero point mm 0.00 0.00
Lower software end position mm 10.00 30.00
Upper software end position mm 90.00 970.00
Positioning tolerance mm 1.00 0.30
Positioning quality class ć 5 3
Maximum speed m/s 2.0 3.0
Maximum acceleration m/s 2 10.0 5.0
Reference speed 1) mm/s 50 50
Reference run mode 1) ć 5 5
1) Not available via control panel
2) This value is saved in the SPC200 as a % value of the Max. mass of the workpiece", and depicted
in WinPISA as a Kg value.
This % value cannot be altered using the control panel.