Festo Кабели и принадлежности - Manual (Page 223)

6. Operating the SPC200 with the control panel
6−11
Festo P.BE−SPC200−EN en 0901d
The top line then shows the selection made as an orientation
aid. The bottom line shows again the current selection possiĆ
bility or in the lowest level entry fields.
In the case of menus which contain axis−specific parameters
or operating functions, the axis identifier of the first axis (N)
will be shown when the menu is opened. In the case of multi−
axis systems, you can select the desired axis with
vV and
by pressing the Enter button. All the following parameters
and operating functions refer to the selected axis.
If, for example, an electric axis is selected, parameters or
operating functions for electric axes are then displayed.
Summary: Moving in the menu system
Purpose Press ...
Confirm the current selection and, if necessary,
change to the next lower level. Enter
Make another selection in the same menu level. { }
Select axis identifier. Vv
Abort selection and change to the next higher level. Esc