Festo Кабели и принадлежности - Manual (Page 149)

4. Commissioning
4−5
Festo P.BE−SPC200−EN en 0901d
4.1 Procedure for commissioning
Fit the components as described in chapter 2. Observe the
installation instructions in chapter 3 when fitting and instalĆ
ling the pneumatic components. Provide a pneumatic emergĆ
ency stop circuit which will put your system into a safe state
in the event of a fault.
If you are using an external measuring system: Check the
mounting position of the measuring system (see also secĆ
tionĂ3.2.7).
Before switching on the compressed air or the stepping
motor controller for electric axes, you must first make known
to the SPC200 the conditions of use in your positioning sysĆ
tem and the type of components used. You can undertake the
necessary settings:
ć with the control panel
ć with the WinPISA software package.
If you use the control panel for commissioning, you should
first be familiar with the functions of the control panel.
Detailed information on this can be found in chapter 6.