Connecting analogue sensors – Festo Кабели и принадлежности User Manual
Page 126
3. Installation
3−48
Festo P.BE−SPC200−EN en 0901d
The voltage range is 0...10 V. Within the possible positioning
range of the axis, you can use a program to define any deĆ
sired range for movement via the analogue nominal value
specification. Voltage value and position have the following
proportion to each other:
Voltage
Description
0 V
...
...
10 V
Smallest position value
...
...
Largest position value
Connecting analogue sensors
Warning
Incorrect installation can lead to faulty operation and
cause e.g. undesired movements of the actuators.
Observe at all costs the following installation instructions.
·
Use a screened cable twisted in pairs for the analogue
nominal value specification.
·
Do not place the signal cables near or parallel to cables
with high levels of interference. If necessary, use separate
wiring channels, separate cable bundles or cables.
·
Always connect the cable screening for the analogue
signal cables on one side to the earth connection (pin 9).
If possible use short signal cables. The maximum cable
length should not exceed 4 m.