Festo Кабели и принадлежности - Manual (Page 254)

6. Operating the SPC200 with the control panel
6−42
Festo P.BE−SPC200−EN en 0901d
6.4 Edit position register
As an alternative to the direct entry of position values (e.g.
X100) when programming, you can also specify positions by
means of the position register. You simply need to enter the
number of the position register (e.g. the program).
In the case of programming with WinPISA, the position regisĆ
ters will be pre−assigned with the values of the position list
(see WinPISA manual).
With the following commands in the menu EDIT PROGRAM
you can fill the position registers with the desired position
values.
Menu EDIT PROGRAM
EDIT PROGRAM
MODIFY POSREG. >
Modify position register
(edit position register)
EDIT PROGRAM
TEACH >
Teach mode
(teach position register)
Modify position register
1. Press the button { or }Ăas often as required in the
basic setting until the menu EDIT PROGRAM is displayed.
2. Press the Enter button in order to open the menu EDIT
PROGRAM. The first command (NEW PROGRAM) will then
be displayed in the bottom line.
3. Select the command MODIFY POSRG with the buttons
{Ăor } and press the Enter button.
MODIFY POSREG.
X:@00