Festo Кабели и принадлежности - Manual (Page 255)

6. Operating the SPC200 with the control panel
6−43
Festo P.BE−SPC200−EN en 0901d
4. Use the cursor buttons to set the desired axis identifier
and the register number, e.g. X:@03, and press the Enter
button. The current value of the register will then be disĆ
played.
MODIFY POSREG.
X:@03 +0123.00
The value −9999.99 is reserved as identifier for unused
position registers.
5. You can now modify the value with the cursor buttons.
Press the Enter button in order to save the modification.
6. If you wish to modify a further position register, press the
Esc button and repeat points 4. and 5..
Teach position register
Warning
With this function one or more axes of the system will be
set in motion. Make sure that nobody can place his/her
hand in the positioning range of the moveable mass whilst
the compressed air supply is still switched on.
The following conditions must be fulfilled for the Teach
mode:
ć the positioning system must be set up completely, wired
and supplied with power and compressed air
ć the axis and application data must be set correctly
ć the inputs ENABLE and STOP must supply a 1−signal.
1. Press the button { or }Ăas often as required in the
basic setting until the menu EDIT PROGRAM is displayed.