Festo Кабели и принадлежности User Manual
Page 147
4. Commissioning
4−3
Festo P.BE−SPC200−EN en 0901d
Contents of this chapter
This chapter describes the commissioning of a pneumatic
axis with the SPC200.
Commissioning is explained using the example of a single−
axis system controlled by an I/O module. The basic proĆ
cedure as well as the description of the I/O control signals is
also relevant for systems with an installed field bus module.
Further information
Before carrying out the commissioning with the control
panel, you should be familiar with the functions of the
control panel. Detailed information on this can be found in
chapter 6.
Information on commissioning with WinPISA can be found in
the WinPISA manual. Information on commissioning on the
field bus or on commissioning electric axes can be found in
the manual for the relevant extension module.