Festo Кабели и принадлежности - Manual (Page 19)

Contents and general instructions
XVII
Festo P.BE−SPC200−EN en 0901d
Information on operating system versions of the SPC200
and software versions of WinPISA
This manual supports the following operating systems and
WinPISA versions:
Operating system Date of validity Associated WinPISA Date of validity
Version 3.8 08−2001 Version 4.1 05−2001
Version 4.1a 06−2002
Version 4.63 10−2003 Version 4.31 10−2003
Version 4.82 12−2004 Version 4.41 12−2004
Version 4.90 03−2006 Version 4.5 03−2006
Version 4.93 11−2008 Version 4.51 11−2008
Please note
The operating system and WinPISA versions are always
downward compatible, i.e. a newer version supports the
capabilities of an older one.
Conversely: Any older version does not support the
expanded and new capabilities of newer versions.
Caution
The functionality of the MMI (control panel) has been
frozen to that of operating system version 3.8. This means
that all new functions from operating system version 4.63
onwards are no longer supported by the MMI.
When commissioning with the MMI, from operating system
version 4.63 onwards, the exact switching cycle of the
ENABLE signal must be observed during the movement
test, see section 4.4.2.
The sole purpose of this change is to increase safety for
persons and the machinery during commissioning.