Festo Кабели и принадлежности User Manual
Page 32
1. Summary of components
1−8
Festo P.BE−SPC200−EN en 0901d
Notes on planning pneumatic axes
Note that in conjunction with the SPC200, the complete
stroke of the drive must not be used. On each side of the
drive positioning must not take place in the range of the
stroke reduction (see appendix A).
Caution
If the range is exceeded, this can lead to impairment of
function and thereby to operating faults.
Please note
For faultless operation of the pneumatic axes with the
SPC200 the following performance limits must be obĆ
served.
Performance limits
Value
Minimum speed
With DGP(I)(L)−... and DNC(I)(M)−...:
50 mm/s
With rotary drive DSMI−...:
40 °/s
Minimum positioning
stroke
With DGP(I)(L)−..., DNC−... and DNC(I)(M)−...:
Ĉ with cylinder lengths of
< 700 mm:
max. 3 % of the stroke length
Ĉ with cylinder lengths of
ţ 700 mm:
20 mm
With rotary drive DSMI−...:
5°
Usable stroke length
or usable swivel angle
Ĉ The best positioning behaviour (reproducibility and positioning time) is
achieved between 10 % and 90 % of the max. stroke length of the
cylinder.
Ĉ The max. permissible positioning stroke of a cylinder is equal to the
max. stroke length minus the stroke reserve of the cylinder, see section
3.4 and appendix A