Festo Кабели и принадлежности - Manual (Page 220)

6. Operating the SPC200 with the control panel
6−8
Festo P.BE−SPC200−EN en 0901d
AXIS
PARAM.
CYL.TYPE 2)
CYL.LENGTH
CYL.DIAMETER
2)
SENSORMEASUREM. 2)
APPLIC.
PARAM. CONTROL
PARAM. TEST/DI
AG.
TOOL LOAD
WORK LOAD
PRESSURE
FITTING POS.
FITTING OFFS.
POS. BASEPOINT
LOWER END POS.
UPPER END POS.
POS. TOLERANCE
QUALITY CLASS
MAX. SPEED
MAX. ACCELER.
GAINFACTOR 2)
DAMPINGFACTOR 2)
FILTER FACTOR 2)
POS. TIMEOUT 2)
SINGLE STEP
INPUT TEST
FB. INPUT TEST
OUTPUT TEST
FB. OUTPUT TEST
FLAG TEST
REGISTER TEST
3 1
X,Y,Z,U 1) X,Y,Z,U 1)
X,Y,Z,U 1)
RESOLUTION
START/STOP FREQ
POS. BASEPOINT
LOWER END POS.
UPPER END POS.
REF. POSITION
REF. SPEED FAC.
MAX. SPEED
MAX. ACCELER.
MODE OF REFER.
MICRO/HALFSTEP
Pneum.
axis
2)
Electric
axis
3)
SYSTEM
AXIS
JOG AXIS
MOVEMENT TEST2)
IDENTIFICATION
2)
EXIT FROM LIMIT 3)
REFER. TRAVEL 3)
X,Y,Z,U 1)
1) Select axis identifier X, Y, Z or U
2) Parameter or function is only available with pneumatic axis
3) Parameter or function is only available with electric axis
2
Enter
Esc
1
Previous page CONFIG. SYSTEM
2
Moving in the menu system
3
See previous page SYSTEM CONTROL
Fig. 6/4: Menu structure on the control panel (continued)