Festo Кабели и принадлежности - Manual (Page 291)

7. Description of the commands
7−25
Festo P.BE−SPC200−EN en 0901d
Identifiers The following identifiers are used during the NC programming
of the SPC200:
Identifier Description
N Identifier for record numbers
G Path conditions
M Help functions
E Jump functions
L Sub−program call
# Single−bit and multibit operations
X, Y, Z, U Axis conditions: X−axis, Y−axis, etc.
F Positioning speed
; Start of comment, valid until end of line *)
. Decimal divider (point)
*) Only for programming with WinPISA
In NC programs the point is used as decimal divider
(e.g.ĂX300.50).