Festo Кабели и принадлежности - Manual (Page 424)

A. Notes on installing the pneumatic components
A−32
Festo P.BE−SPC200−EN en 0901d
An operating system as from version 4.82 is required for
operating this drive.
For commissioning, WinPISA from version 4.41 is additionally
recommended.
Warning
There is a danger of injury caused by pressure forces
which can eject the sensor if the connecting screws are
loosened under pressure.
· Make sure that the following sources of power are
switched off:
Ĉ operating voltage
ć compressed air (drive vented on both sides).
The sensor projects into the pressure chamber of the
DNCI−... .
Fig. A/23: Sensor connection