Festo Кабели и принадлежности - Manual (Page 256)

6. Operating the SPC200 with the control panel
6−44
Festo P.BE−SPC200−EN en 0901d
2. Press the Enter button in order to open the menu EDIT
PROGRAM. The first command (NEW PROGRAM) will then
be displayed in the bottom line.
3. Select the command TEACH with the buttons { or }
and press the Enter button.
TEACH SELECT
X:@00 CONT
4. Use the cursor buttons to set the desired axis identifier,
the register number and the positioning mode.
The following positioning modes are possible:
Positioning
mode Description
CONT Position continuously
STEP Position in steps twice the set positioning
tolerance
5. Press the Enter button in order to confirm the selected
positioning mode. The current position will then be
displayed in the bottom line.
TEACH:@03 CONT
X:+0123.00 +