Festo Кабели и принадлежности - Manual (Page 269)

7. Description of the commands
7−3
Festo P.BE−SPC200−EN en 0901d
Contents of this chapter This chapter contains basic information on programming the
SPC200 with the control panel. Both the coordinated and the
autonomous mode of operation are explained and all the NC
commands are described.
Further information Before programming with the control panel, you should be
familiar with the functions of the control panel. Chapter 6
describes how to create, start and edit NC programs with
the control panel.
WinPISA offers user−friendly editing functions. Information on
this can be found in the WinPISA manual.