Festo Кабели и принадлежности - Manual (Page 247)

6. Operating the SPC200 with the control panel
6−35
Festo P.BE−SPC200−EN en 0901d
6.3.3 Store of commands on the control panel
The operating system of the SPC200 offers as from version
4.6, in conjunction with WinPISA as from version 4.3, an
extended scope of functions due to the support of new NC
commands and extended NC syntax. As from operating
system version 4.6, position registers (@n) can also be used
for saving speed and acceleration values.
Please note
Programs which use the new NC commands and the
extended NC syntax of operating system version 4.6 or
higher
cannot be displayed and cannot be edited with
control panel type SPC200−MMI−1... .
An overview of the new NC commands as well as a detailed
description of all NC commands with programming examples
can be found in chapter 7.4.