Festo Кабели и принадлежности - Manual (Page 227)

6. Operating the SPC200 with the control panel
6−15
Festo P.BE−SPC200−EN en 0901d
With the buttons vV you can now select the axis, the paraĆ
meters of which you wish to modify. When the axis has been
selected, the bottom line will show the current parameter
setting.
In order to modify a parameter, position the cursor on the
desired figure of the displayed parameter with the buttons
{ }. With the buttons vV you can now modify the figure.
If you modify a parameter value, the character ? will be
shown in the bottom line.
CYL. TYPE
X: 1
1
2
3
5
Enter
CYL. TYPE
X: 2 ?
CYL. TYPE
X: 2
1
Character flashes (here underlined) = current cursor
position
2
Identifier for value modification
3
New value accepted (? No longer visible)
Fig. 6/7: Set parameter values