Festo Кабели и принадлежности - Manual (Page 64)

2. Fitting
2−8
Festo P.BE−SPC200−EN en 0901d
1
Locks
automatically
2
Direction for
unlocking
3
Guide rail
4
Contact strip
5
Front plate of the
module
6
Locking lever
1
2
3 4
5
6
Fig. 2/1: Installing the modules
Removing modules Proceed as follows when removing a module:
1. Switch off the compressed air supply and the operating
voltage supply.
2. Disconnect and remove the connecting cable from the
front of the module.
3. Unlock both locking levers (see Fig. 2/1) and carefully
remove the module.
4. If necessary, seal the unused connections with blanking
plates.