Festo Кабели и принадлежности - Manual (Page 239)

6. Operating the SPC200 with the control panel
6−27
Festo P.BE−SPC200−EN en 0901d
6.3 Edit program
The control panel provides you with an Editor with which you
can edit both position registers as well as NC programs. If
your positioning system is set up completely, you can teach
position registers with the aid of the Teach functions.
All menu commands for editing NC programs and position
registers as well as the Teach function can be found in the
menu EDIT PROGRAM.
Please note
Programs which use the new NC commands and the
extended NC syntax of operating system version 4.6 or
higher
cannot be displayed and cannot be edited with
control panel type SPC200−MMI−1... .
Menu EDIT PROGRAM (Edit program)
EDIT PROGRAM
NEW PROGRAM >
Create new program
EDIT PROGRAM
MODIFY PROGRAM >
Modify program
EDIT PROGRAM
DELETE PROGRAM >
Delete program
EDIT PROGRAM
MODIFY POSREG. >
Modify position register
EDIT PROGRAM
TEACH >
Teach mode
(teach position register)
These commands are explained in the following sections.