Festo Кабели и принадлежности - Manual (Page 83)

3. Installation
3−5
Festo P.BE−SPC200−EN en 0901d
3.2 General instructions on fitting the pneumatic components
Please note
Faults in the axis set−up can lead to malfunctioning.
Observe all the instructions on installing pneumatic comĆ
ponents. Set up the system with great care. Only then can
you guarantee faultless operation.
The following sections contain general instructions on instalĆ
ling pneumatic components. These instructions apply to all
the drives mentioned here. Special installation instructions
related to a certain drive can be found in appendix A.
Please note
It is necessary to carry out system identification during the
first commissioning, when components are replaced, as
well as when the drive configuration is modified
(e.g. mounting position, tubing or supply pressure),
(see section 4.4.2).
3.2.1 the compressed air supply
For protecting the proportional directional control valve
against damage you will require a service unit with a 5 Ģm
filter.
· Use only dry non−lubricated 5 Ģm filtered compressed air
4...8 bar, tolerance ± 1 bar. Note the permitted pressure
range of the components used.