Festo Кабели и принадлежности - Manual (Page 262)

6. Operating the SPC200 with the control panel
6−50
Festo P.BE−SPC200−EN en 0901d
6.7 Set controller factors
Menu REGUL. PARAM The controller parameters for pneumatic axes are ascertained
by the SPC200 from various basis parameters. The controller
factors are standardized at 1.0. By means of these factors
you can manually influence the ascertained controller paraĆ
meters.
A detailed description of the controller factors as well as
instructions on optimizing the positioning behaviour can be
found in appendix B.