Festo Кабели и принадлежности - Manual (Page 148)

4. Commissioning
4−4
Festo P.BE−SPC200−EN en 0901d
Warning
Before carrying out installation and/or maintenance work,
switch off the following in the sequence specified:
1. the compressed air supply
2. Load and operating voltage supplies on the SPC200 and,
if applicable, load voltage supply on the axis interface
string.
You can thereby avoid:
ć uncontrolled movements of loose tubing
ć uncontrolled movements of the connected actuators
ć undefined switching states.
Caution
The SPC200 is set at the factory to certain axis and apĆ
plication data. Before applying compressed air, you must
adapt these settings to your application and to the axes
which you are using.
You can thereby avoid:
ć uncontrolled movements of the connected actuators.
Please note
From operating system 4.31 onwards it is recommended to
carry out configuration and commissioning of the SPC200
with the latest version of WinPISA.
Only the latest version of WinPISA provides you with
simple and comprehensive support and the use of all
features of the SPC200.