Festo Кабели и принадлежности - Manual (Page 417)

A. Notes on installing the pneumatic components
A−25
Festo P.BE−SPC200−EN en 0901d
For this drive an operating system as from version 4.6 and
WinPISA as from version 4.3 are required.
Valve−drive combinations with DSMI−...
Recommendation: Use only suitable valve−drive combinaĆ
tions. The following table shows valve−drive combinations for
type DSMI−... as well as the dimensions of the compressed air
tubing and tube connectors.
Horizontal mounting position
Type
DSMI Valve type MPYE−... Screw connectors for Tube type PUN
DSMI−...
MPYE−... DSMI−...
DSMI−25−... MPYE−5−M5−010B QSM−M5−6 QSM−M5−6 PUN−6x1
DSMI−40−... MPYE−5−1/8−LF−010B QS−1/8−8 QS−1/8−8 PUN−8x1.25
Permitted mounting positions
In the application data you must always specify 0 [°] for the
rotary module under Mounting position" (see also chap. 6.2).
The mounting position which is permitted depends on the
position of the mass centre of gravity. A distinction is made
between the following cases: