Festo Кабели и принадлежности - Manual (Page 215)

6. Operating the SPC200 with the control panel
6−3
Festo P.BE−SPC200−EN en 0901d
Contents of this chapter This chapter describes the menu and operating functions of
the control panel type SPC200−MMI−...Ă.
All parameters and operating functions of pneumatic axes are
explained in detail and general system operating functions
are described.
Control panel functions of special extension modules such as
stepping motor indexer modules and field bus modules are
simply listed without a description.
Further information Control panel functions of stepping motor indexer modules
and of field bus modules can be found in the manual for the
relevant module.
WinPISA offers mainly the same operating functions and
parameters as the control panel. Information on this can be
found in the WinPISA manual.
Caution
The functionality of the MMI (control panel) has been
frozen to that of operating system version 3.8. This means
that all new functions and new or expanded NC commands
(see chapter 7.1.4) from operating system version 4.63
onwards are no longer supported by the MMI.
When commissioning with the MMI, from operating system
version 4.63 onwards, the exact switching cycle of the
ENABLE signal must be observed during the movement test,
see chapter 4.4.2.
The sole purpose of this change is to increase safety for
persons and the machinery during commissioning.
Please note
From operating system version 4.63 onwards, it is recomĆ
mended to carry out commissioning and programming
only with WinPISA version 4.31 or later.
Non−compatible
as from
OS 4.63