Festo Кабели и принадлежности - Manual (Page 397)

A. Notes on installing the pneumatic components
A−5
Festo P.BE−SPC200−EN en 0901d
Installation instructions for drives DGP(L)−... and
DGPI(L)−...
ć Any mounting position is permitted (horizontal, vertical or
diagonal)
· Note that in conjunction with the SPC200, the complete
stroke of the drive must not be used.
Permitted work stroke = stroke length minus stroke
reduction
1
Permitted work
stroke = (stroke
length minus
stroke reduction)
2
Stroke reduction
1
2
Fig. A/3: Permitted working stroke
On each side of the drive positioning must not take place in
the range of the stroke reduction (see also section 3.4).
ć The best possible positioning behaviour can be
achieved if you use only 80 % of the stroke length of
the drive, symmetrically to the two end positions.
ć If demands placed on the positioning behaviour are
only slight, observe at least the following stroke reĆ
ductions in both end positions:
Pistonj [mm] 25 32 40 50 63
Stroke reductionper end position [mm] 25 25 35 35 35