Festo Кабели и принадлежности - Manual (Page 240)

6. Operating the SPC200 with the control panel
6−28
Festo P.BE−SPC200−EN en 0901d
6.3.1 Create new program
1. Press the button { or }Ăas often as required in the
basic setting until the menu EDIT PROGRAM is displayed.
SPC200 READY
EDIT PROGRAM >
2. Press the Enter button in order to open the menu EDIT
PROGRAM. The first command (New program) will then be
displayed in the bottom line.
EDIT PROGRAM
NEW PROGRAM >
3. Press the Enter button in order to select the command.
NEW PROGRAM
PROGRAM NO.: 00?
4. Programs 0 and 1 are already created at the factory. Use
the cursor buttons to set the desired program number of
a non−existent program, e.g.:
NEW PROGRAM
PROGRAM NO.: 03?
5. Press the Enter button in order to create the program.
When the program has been created, you can edit the
first NC record.
For displaying an NC record both lines of the display are
used. This is to be regarded as one line with 32 characters.
When programming multi−axis systems, note that for reasons
of space only the parameters for the currently selected axis
are displayed.