Festo Кабели и принадлежности - Manual (Page 225)

6. Operating the SPC200 with the control panel
6−13
Festo P.BE−SPC200−EN en 0901d
6.2 Setting project−specific parameters
Warning
Incorrectly set parameters can lead to uncontrolled reacĆ
tions of the connected axes during operation.
The SPC200 must know the conditions of use in your project
and the type of components used in your positioning system.
Undertake the necessary settings in the following menus:
Menu Description
SPC200 READY
AXIS PARAM. >
Axis data
Specifications on the axes used
SPC200 READY
APPLIC. PARAM. >
Application data
Specifications on the conditions of use
SPC200 READY
CONFIG. SYSTEM>
System configuration
Operating mode, starting programs,
hardware configuration
From operating system version 4.63 onwards, the DSMI rotary
drive is supported by the SPC200. It cannot be configured or
parametrized using the MMI. Please use WinPISA, version
4.31 or higher.
From operating system version 4.82 onwards, the piston rod
drive of the DNCI family with integrated incremental measurĆ
ing system is supported by the SPC200. It cannot be confiĆ
gured or parametrized using the MMI. Please use WinPISA,
version 4.41 or higher.
Proceed as follows:
If you have selected a parameter in a menu by pressing the
Enter button (see chapter 6.1.1), the text in the display will
roll upwards.
New feature
as from
OS 4.63
New feature
from
BS 4.82