Festo Кабели и принадлежности User Manual
Page 72
2. Fitting
2−16
Festo P.BE−SPC200−EN en 0901d
2.4
Fitting the axis interface and the I/O function module
This section explains how to fit the axis interface type
SPC−AIF−... and the I/= function module type SPC−FIO−... .
Fitting the axis interface
Fit the axis interface as close as possible to the relevant
drive. The length of the cable to the measuring system
should be approx. 500 mm.
The axis interface type SPC−AIF−... must be fitted on a flat
surface.
·
Fasten the axis interface with at least 3 M4 screws.
The dimensions for the threaded holes for screw size M4 are
shown in Fig. 2/8 and Fig. 2/9.
Fig. 2/8 shows the current design of the axis interfaces of
type SPC−AIF−POT, ...−LWG and ...−MTS.
For older axis interfaces, separate support brackets are
necessary. These enable horizontal or vertical fitting with the
middle holes shown in Fig. 2/8 (dimension 16.9 mm"), see
the brief description supplied with the product.
The axis interfaces of type SPC−AIF−POT, ...−LWG, ...−MTS can
be fitted vertically. Separate support brackets (accessories)
are necessary here.