Festo Кабели и принадлежности - Manual (Page 252)

6. Operating the SPC200 with the control panel
6−40
Festo P.BE−SPC200−EN en 0901d
When a program has been selected, the program number will
be displayed in the first three columns (here P03). The first
NC record of the program is shown after this, e.g.
P03:N000 G00 *
X+0100.00
The cursor is positioned on the identifier for the NC record
number (here N000). With the buttonsĂ
vV you can page
through all the NC records of the program.
Note when programming multi−axis systems that, for reasons
of space, only the parameter for the currently selected axis
can be displayed.
Instructions on editing can be found in chapter 6.3.2.