Festo Кабели и принадлежности - Manual (Page 241)

6. Operating the SPC200 with the control panel
6−29
Festo P.BE−SPC200−EN en 0901d
The procedure for editing an NC record is explained using as
an example the command G00 (Position at highest possible
speed). This is followed by an overview of all available NC
commands. A detailed description of the NC commands with
program examples can be found in chapter 7.4.
Example: NC record with G00
When a program has been created, the number of the created
program will be displayed in the first three columns (here P03).
After this the NC record number N000 is shown.
P03:N000 * *
X*
The cursor is positioned on identifier N.
1. Press button } in order to position the cursor on the first
NC word of the current NC record (here * for positioning
with saved values).
With the buttons vV you can now select the desired NC
command.
2. Press button v in order to switch to G00.
P03:N000 G00 *
X+0000.00
3. Press button } when you have selected the desired
command.
P03:N000 G00 *
X+0000.00
4. With the buttons vV you can now select further NC
words or parameters for the NC command. Press button
} when you have undertaken the setting.
P03:N000 G00 *
X+0000.00