Festo Кабели и принадлежности - Manual (Page 410)

A. Notes on installing the pneumatic components
A−18
Festo P.BE−SPC200−E N en 0901d
An operating system as from version 4.6 is required for operĆ
ating this drive.
Caution
The standard cylinder and the measuring system are
mounted symmetrically at the factory. Do
not loosen the
mechanical connections between the standard cylinder
housing and the measuring system housing. When fitting
the coupling plate, observe the operating instructions for
the DNCM−...−POT.
Fig. A/13: Do not loosen the mechanical connection