Festo Кабели и принадлежности - Manual (Page 270)

7. Description of the commands
7−4
Festo P.BE−SPC200−EN en 0901d
7.1 General instructions on programming
You must take the following into account when creating NC
programs:
ć the operating mode in which you intend to use the
SPC200.
In Start/Stop mode all NC commands are supported. In
Record Select mode only positioning commands, posiĆ
tioning conditions and commands for setting the posiĆ
tioning quality class are supported.
ć the number of fixed starting programs.
If a single or multi−axis system is controlled by an
SPC200, only one starting program is usually defined. If
two independent work stations are controlled, a separate
starting program must be defined for each work station
(autonomous operation of two work stations).