Festo Кабели и принадлежности User Manual
Page 38
1. Summary of components
1−14
Festo P.BE−SPC200−EN en 0901d
Components
You will require the following components for setting up a
pneumatic axis:
ć
the SPC200 axis controller
ć
an axis interface type SPC−AIF−...
ć
a proportional directional control valve
typeĂMPYE−5−...−010B
ć
a measuring system type MLO−POT−...−TLF,
typeĂMLO−POT−...−LWG or type MME−MTS−...−TLF−AIF or a
drive with integrated measuring system
ć
a permitted drive
ć
if necessary, further components for the drive, e.g. a
mechanical guide, a coupling etc. (see appendix A.)
ć
a service unit with 5 Ģm filter
ć
a 24 V DC power supply
ć
if necessary, components for a pneumatic emergency
stop circuit.
The SPC200 Smart Positioning Controller takes control of the
following tasks:
ć
specification of the nominal positions by positioning
control
ć
comparison of the nominal and actual positions and posiĆ
tioning control by means of the proportional directional
control valve (status control)
ć
optimization of the controller behaviour by parameter
adaptation
ć
control of the peripherals via digital inputs and outputs
and sequence control.