Festo Кабели и принадлежности - Manual (Page 238)

6. Operating the SPC200 with the control panel
6−26
Festo P.BE−SPC200−EN en 0901d
Proceed as follows:
1. Select the parameter which you wish to modify
(seeĂchapter 6.1.1).
2. Press the Enter button in order to confirm the selection.
The current parameter value for the selected axis will
then be displayed in the bottom line.
3. With multi−figure values:
Position the cursor with the buttons { or } on the
figure of the parameter value which you wish to modify.
4. Set the figure value with the buttons ĂvV.
5. Repeat points 3 and 4 if you wish to modify further
figures.
6. Press the Enter button. The value will then be transferred
to the SPC200.