Festo Кабели и принадлежности - Manual (Page 245)

6. Operating the SPC200 with the control panel
6−33
Festo P.BE−SPC200−EN en 0901d
6.3.2 Instructions on editing
Failure of the operating voltage before the NC editor is exited
will therefore lead to loss of the modifications undertaken.
When entering extensive programs exit the Editor now and
then in order to save intermediately.
When programming pay attention to correct syntax and use
only existing operands. Both lines of the display can be used
for showing an NC record. Note when programming multi−axis
systems that, for reasons of space, only the parameter for the
currently selected axis can be displayed.
When the cursor is moved, the lines are to be regarded as
one line with 32 characters. With the buttons
{ and } the
individual NC words or parameters are selected one after the
other. The cursor wanders accordingly to the left or to the
right.
Insert, delete line If the NC program already contains several lines, NC records
can be inserted and deleted and you can page through the
program. For this purpose the cursor must be positioned on
identifier N (NC record number) (e.g. N001). You can then:
ć page through the program with the buttons vV
ć insert a copy of the current NC record by pressing the
Enter button
ć delete the current NC record by pressing the Esc button.
The delete procedure is quitted with Enter or rejected
with Esc.
Editing lines With the buttons { and } the character or NC word to be
modified will be selected. With the buttons vV the charĆ
acter or the NC word will be modified.