Festo Кабели и принадлежности - Manual (Page 51)

1. Summary of components
1−27
Festo P.BE−SPC200−EN en 0901d
Theme Functions Control
panel WinPISA
Configuration Ĉ Entering axis data
Ĉ Entering application data
Ĉ Entering controller data ĩ 1)
ĩ 1)
ĩ
ĩ
ĩ
ĩ
Programming Ĉ Entering programs
Ĉ Entering positions
Ĉ Teach Editor for positions
Ĉ Project backup functions
Ĉ New NC syntax and new NC commands ĩ
ĩ
ĩ
ć
ć ĩ
ĩ
ĩ
ĩ
ĩ
2)
Commissioning Ĉ Test functions for components
Ĉ Program test in single steps
Ĉ Extended test functions
Ĉ Uploading/downloading programs
Ĉ Starting and stopping programs ĩ
ĩ
ć
ć
ĩ ĩ
ĩ
ĩ
ĩ
ĩ
Service Ĉ Updating the SPC200 firmware by downloading
Ĉ Reading out statistic diagnostic data ć
ć ĩ
ĩ
Analysis and
Optimization Ĉ Graphical representation of measured data
Ĉ Entering extended system data ć
ć ĩ
ĩ
1) If they correspond to operating system version 3.8, see also page XVI
2) Only in conjunction with operating system versions 4.6 and WinPISA from version 4.3 onwards