Festo Кабели и принадлежности - Manual (Page 65)

2. Fitting
2−9
Festo P.BE−SPC200−EN en 0901d
2.2 Fitting the basic unit
You can fit the SPC200 into a control cabinet in one of two
ways:
ć by screwing it directly to the wall of the control cabinet
ć by means of a hat rail.
Please note
Fit the SPC200 or the hat rail so that there is sufficient
space (above or below for heat dissipation 40 mm).
Screwing the SPC200 to the wall
You will require:
ć a mounting surface of approximately 126 x 120 mm 2
ć four threaded holes for screw size M4
(dimensions see following diagram).
94 mm
1
1
SPC200−CPU−4: 117 mm
SPC200−CPU−6: 158 mm
Fig. 2/2: Screwing the SPC200 to the wall