Festo Кабели и принадлежности - Manual (Page 296)

7. Description of the commands
7−30
Festo P.BE−SPC200−EN en 0901d
7.4 Explanation of the NC commands
Identifying supported NC commands
Operating mode In Start/Stop mode all NC commands are supported. NC
commands, which are supported in the Record Select mode,
are marked as follows:
ć permitted in operating mode: Start/Stop, Record Select
Axis type If the description refers to a particular axis type, this is also
marked.This means:
Axis type Description
Ĉ Pneumatic axis The description of the NC command
refers to the pneumatic drives
Ĉ Stepping motor axis The description of the NC command
refers to the stepping motor axes
If no identification is given for a particular axis type, the comĆ
mand description for both axis types is valid.