Festo Кабели и принадлежности - Manual (Page 246)

6. Operating the SPC200 with the control panel
6−34
Festo P.BE−SPC200−EN en 0901d
· If the cursor is positioned on an NC word, an NC word will
be selected with
vV.
· If the cursor is positioned on a figure, the figure value will
be increased or decreased with
vV.
· If the cursor is positioned on the axis identifier, one of the
existing axes will be selected with
vV.
· With positioning commands, one of the following charĆ
acters can be selected on the right next to the axis identĆ
ifier:
Sign Meaning
+ Positive position value (e.g. X+0100.00)
− Negative position value (e.g. X−0100.00)
@ Number of the position register (e.g. X@10)
* Axis not relevant (e.g. Y*; Y−axis not relevant)
If the character * is selected, the command programmed in
the current line for the selected axis is not relevant, e.g.:
P03:N001 G00 G90
Y*
Conclude entry In order to conclude the entry of an NC record or program,
the cursor must be positioned on an NC command, paraĆ
meter or operand. The NC record is concluded with the Enter
button. Program entry is concluded with the Esc button.