NXP Semiconductors LPC24XX UM10237 - Manual (Page 752)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 752 of 792
NXP Semiconductors
UM10237
Chapter 35: LPC24XX RealMonitor
4.5 Prefetch Abort mode
RealMonitor uses four words on entry to its Prefetch abort interrupt handler.
4.6 Data Abort mode
RealMonitor uses four words on entry to its data abort interrupt handler.
4.7 User/System mode
RealMonitor makes no use of this stack.
4.8 FIQ mode
RealMonitor makes no use of this stack.
4.9 Handling exceptions
This section describes the importance of sharing exception handlers between
RealMonitor and user application.
4.9.1 RealMonitor exception handling
To function properly, RealMonitor must be able to intercept certain interrupts and
exceptions.
Figure 35–151 illustrates how exceptions can be claimed by RealMonitor
itself, or shared between RealMonitor and application. If user application requires the
exception sharing, they must provide function (such as app_IRQDispatch ()). Depending
on the nature of the exception, this handler can either:
• Pass control to the RealMonitor processing routine, such as rm_irqhandler2().
• Claim the exception for the application itself, such as app_IRQHandler ().
In a simple case where an application has no exception handlers of its own, the
application can install the RealMonitor low-level exception handlers directly into the vector
table of the processor. Although the irq handler must get the address of the Vectored
Interrupt Controller. The easiest way to do this is to write a branch instruction (